High quality, self-adhesive LED strips. The LEDs are connected in blocks of 3 so the strip can be cut in
between each of these blocks. There are markings on the PCB showing where to cut, also there are
solder pads on the PCB showing where wires can be re-connected to the cut part, this can then be
connected to 12V.
The LED strips require 12V for optimum performance, but will also work happily from a 3 cell (11.1V) lipo
battery. Although the strips will work from lower voltages (reasonable light can still be optained as low as
9.0V) there is a marked reduction in brightness.
Operating voltage: 12.0V dc
Current requirement: 400mA per m
LED strip Comparison Table
LEDs / m
Current / m
Minimum cut size
Standard, High Density
High Power, High Density