Intelligent 3000mA Smart Charger for 4.8V-12V NiMH NiCd Race RC Batteries Vapex

In stock
SKU
VP24W
£12.95
New Design Charges 4-10 cell NiCd or NiMH battery packs. (4.8V - 12V) Delta-Peak microprocessor controlled charging, switches to trickle charge once pack is charged. LED shows when charging & when complete. UK 3-pin mains plug

Smart & Fast Charger for 4~10 Cells Battery Packs


This Charger is designed to charge Nickel-Metal Hydride or Nickel Cadmium 4~10 Cells battery packs with Standard Tamiya Male Connector. This is a Smart Charger, which can distinguish 4~10 cells pack by MPU inside Automatically and cut-off the charging accordingly. It is easy to use. Manual-adjustment is not needed. By using different adaptors, this charger can be used to charge battery packs with Futaba Female connector, JR Female connector, Tamiya Small Male connector, Micro Female connector etc.


Input Rated Voltage & Line Frequency: 240VAC 50Hz
Rated Voltage: DC18.0V+-5%
Rated Current: DC1300mA
Rated Cells Pack: 4~10 Cells
No Load Voltage: DC20V Max
Trickle Current: 60mA Max
Short Circuit & Reverse Polarity
Protection included


Features:

 

  • Recharges 4~10 pieces cells battery packs 
  • Ni-MH/Ni-Cd batteries with Standard Tamiya 
  • Male connector. 
  • Microprocessor-control System (For protection and safety). 
  • Batteries life is well protected by –dV detection and timer protection. 
  • LED display for Rapid charge/trickle charge 
  • Red LED- rapid charge 
  • Green LED- Fully Charged & trickle charge 
  • Flash Red and Green LED- short 
  • Flash Red LED: Reverse polarity or Wrong Battery 
  • Safety features:  -dV cut-off function 

OPERATION INSTRUCTIONS :

  1. Connecting 1 pack of 4~10 cells pack with Tamiya Male connector to the Female connector of the charger. 
  2. Make correct contact of the Female and Male connectors. 
  3. Plug charger into mains socket. 
  4. The status LED will glow Red when the batteries are receiving charge. After charge is completed, the status LED will change green to indicate that the charge is completed and batteries are ready for use. Once the status LED is Green, the charge switches to trickle mode to keep the batteries at full. 
  5. Unplug the charger and remove the batteries from the charger when not in use. 

Mechanical Specification:

  1. Plastic Case: 60×42×20mm 
  2. Output DC Cord: 24AGW×1500mm×2C 

Environmental
Operating temperature: 0~35℃
Short Circuit Protection: 20mA


Charging Table

Battery PackOutput CurrentInput
4.8V - 6.0V3A18V/1.35A
7.2V - 9.6V2A
10*8V - 12.0V1.5 A

Charging time for 4.8V~6.0V NiMH Packs

SizeVapex Battery TypeCharging Time
950mAhin950AAA30mins
1600mAhVP1600AFP, VP1600AF50mins
2000mAhVP2000AFP, VP2000AAFP VP2000SC1.1hrs
2200mAhVP2200SCS1.3hrs
2500mAhVP2500SC, in2500AA1.5hrs
2600mAhVP2600AA1.6hrs
3300mAhVP3300SC2hrs
3700mAhVP3700SC2.2hrs
4300mAhVP4300SC2.4hrs
4600mAhVP4600SC2.5hrs
5000mAhVP5000SC2.8hrs
5300mAhVP5300SC3hrs

 

 Charging time for 7.2V~9.6V NiMH Packs

SizeVapex Battery TypeCharging Time
950mAhln950AAA35mins
1600mAhVP1600AFP, VP1600AF1hr
2000mAhVP2000AFP, VP2000AAFR, VP2000SC1.3hrs
2200mAhVP2200SCS1.6hrs
2500mAhVP2500SC,1.8hrs
2600mAhVP2600AA2hrs
3300mAhVP3300SC2.4hrs
3700mAhVP3700SC2.5hrs
4300mAhVP4300SC2.8hrs
4600mAhVP4600SC3hrs
5000mAhVP5000SC3.3hrs
5300mAhVP5300SC3.6hrs

 

 Charging time for 10.8V~12V NiMH Packs

SizeVapex Battery TypeCharging Time
950mAhln950AAA40 mins
1600mAhVP1600AFP, VP1600AF1.1hrs
2000mAhVP2000AFP, VP2000AAFP, VP2000SC1.5 hrs
2200mAhVP2200SCS1.8hrs
2500mAhVP2500SC, in2500AA2hrs
2600mAhVP2600AA2.2hrs
3300mAhVP3300SC2.8hrs
3700mAhVP3700SC3hrs
4300mAhVP4300SC3.2hrs
4600mAhVP4600SC3.5hrs
5000mAhVP5000SC3.8hrs
5300mAhVP5300SC4hrs

 

*Charge time will vary depending upon the brand,
capacity and condition of batteries being
charged.

Important Safety Instructions

  1. Before charging, read instruction. 
  2. This charger is intended for use with Nickel-Cadmium and Nickel-metal-hydride rechargeable batteries only. Attempting to charge other types of batteries may cause personal injury and damage to the charger. 
  3. Recharge only one type of battery (Ni-Cd or Ni-MH) at each time. 
  4. Do not expose charger to rain or moisture. For indoor use only. 
  5. Remove from mains when not in use. 
  6. Never use an extension cord or any attachment not recommended by manufacturer, otherwise this may result in a risk of fire, electric shock or injury to persons. 
  7. Do not operate the charger if it has been subjected to shock or damage. Take it to a qualified serviceman for repair. 
  8. Do not disassemble the charger. Incorrect reassembly may result in a risk of electric shock or fire. 
  9. Unplug the charger from outlet before attempting any maintenance of cleaning.
More Information
SKU VP24W
Gift Type Virtual
Write Your Own Review
You're reviewing:Intelligent 3000mA Smart Charger for 4.8V-12V NiMH NiCd Race RC Batteries Vapex

Brands

Component Shop
VP Racing
Leopard Hobby
VP Flight
Vapex-Tech
VP Airsoft
Giant Power
Minwa
GP Batteries
Warton Metals Limited
ACTion Electronics
Eneloop
Eneloop Pro
OUTDO (Huawei)
Intelligent 3000mA Smart Charger for 4.8V-12V NiMH NiCd Race RC Batteries Vapex